posted 01-07-2000 08:24 AM         

The cheap one's do not seem to work i don't know the difference between the different brands but they are NOT the same.

Yes it gives the good stuff.The setup is somewhat different the electrolyte is only 2-3% sulfuric solution 5% is to strong.The only way the ester has been formed is 1 gram of purified red hot pseudoephedrine crystals and only 5ml of ACS GAA and 3 drops of ACS 98% sulfuric.
It seems pseudoephedrine does not like to work if the electrolyte is to strong.The palladium ingot was also done a bit different how it was done was both sides was anodized with palladium black oxide.Both sides charged and the ingot about 1/2 inch off the side of the beaker so the solution could come it contact with both sides.

The voltage it took to anodize the ingot was 10 volts at about 3 amps the reason it was so high was because of the 3% electrolyte.When wiring turned around every thing seem to work at the right level volt's and amp wise.The run time was 2.30 hours the yield was around 65-70% should run longer to get a better octane i think around 3 hours would be it.